Contact Us

ADD:Wutan Industrial Area, Longqan City, Zhejiang Province, China






Home > News > Content
Samurai Sword Fixed Blade Angle
Oct 11, 2017

samurai sword Fixed blade Angle

The generic hand that honed the sword

1. Whatever tools you grind or use (Lansky, Spyder, grindstone... Whatever), the first requirement is grinding to keep edge of fixed blade Angle, it takes practice, but there is a veteran knows tips with singular pen before grinding is painted the edge area of the black first, then take it to light grinding after a few times, examine the blade area, if the Angle is correct, then wear black is complete, if not, your observation Mark area after the adjustment point of view, caught the Angle after will feel remember, later in this feeling. This method can be applied to new hands, because different angles can be used to adjust the feeling in different angles.

On this side, there is a myth that you can think about whether every one of them should keep the original blade Angle. From the point of view of the sword collector, this is not to be doubted. But from the consumer point of view, I think is questionable, I usually according to their use habits, to change the blade Angle, can make in hand to do the biggest application, but the premise is "if you want to change blade Angle, you still want to maintain constant change after the blade Angle".

2. When you can fix the edge of the blade in the grinding, start to enter the most critical program: the degree of grinding. Grinding is a kind of cutting thin grinding material to manufacture the new front sharp blade to blade area (edge) process, so the function of the millstone as subject, coarse grinding is in the process, make the blade, fine grinding is occurring in the process of removing coarse grinding burrs, light is to further strengthen the functions of fine grinding. It can be seen from this that the grinding of the key in the rough grinding procedure, if you have been grinding bad, must start from this place to strengthen again.

Generally speaking, if the Angle of the blade needs to be reshaped or changed to a thin blade Angle, we usually make a rough grinding from 600 grit stone, and grind it according to the main point of 1. The edge of the blade is at the edge of the edge of the edge. The edges indicate that you actually make a new frontal area, because your abrasive surface has reached the edge of the edge. The flip side, according to the same point grinding again, until the other side of the blade and burrs (some teachers only side went to flash that complete grinding procedure (Chisel Grind so it), next time again from the other side of the grinding).

If you do step 2, you've already done 80 percent of the work you've finished (and you're already feeling pretty good with your hands in the vertical direction), and the rest is just going to the rough side.

Deflashing available from grit stone of 1000 or 1200 in accordance with the foregoing ahead will have burrs blade with the power of the medium (compared to department step 2) check the blade surface after gently mill about 10 times, should be on the other side of the blade and the raw edges, but the flash is a department of step 2. Turned face to the same point again after grinding under ten again, the next step is to use small power is almost itself (weight), will improve the blade a little Angle (about 5 degrees), light wear flip side again after three or four according to the main point grinding with three or four. B: Ok, you get it.

The above mentioned process is just general, individual can depend on habit or plant, steel is different, oneself add and subtract, but the program is probably like this. If you are still undoing (unlikely), start at step 2 and do the next step after the brush.